1) clean the screen

Wipe the screen in indoor calm, clean environment, in order to reduce the influence of dust on the film coating, because before the film is completely clean is necessary this surely we all know, if carelessly moistens the dust will directly affect the results to the film, light to cause film gas bubble, heavy then lead to failure of the film.

2) in the use of cloth after cleaning, if the screen and stubborn dirt, do not use wet cloth to clean the water that is very important. As long as the BG paste in the dust on the dust, and then set off, the dedusting paste viscosity force dust.

3) the protective film from the packages take out, first do not tear off membrane, directly into the phone's screen, get the preliminary film impression, especially observe the fit of the film edge and mobile phone screen, foil position have a general understanding, which will help to stick behind film program of.

4) will mark "1" off the film tear a part, and pay attention to avoid the finger touch the protective film adsorption layer. Each protective film is divided into three layers, the first and the second is the isolated film, which is the protective film.

5) will protect the membrane of the adsorption layer on the screen edge angle, be sure to ensure that the position alignment, and then carefully paste. One side, paste, apart from the film, if the film produced in the process of bubble, to pull the film, re paste.

6) confirm the film position completely correct, then the number from the film completely open. After the whole protective film are affixed to the screen, if it is found that there are bubbles if available BG scratch card about the air blowing screen.

7) from the film completely open.

8) wipe the screen with cloth, the whole process of the completion of the film.